What is Low Voltage?

In the HVAC vocabulary Low Voltage usually means 24 volt control wires from the heater to a low voltage wall thermostat. The wire is very small and much cheaper for longer runs. Most of our wall heaters do not use low voltage thermostat or wires because of the added cost of the transformer. A transformer is a device that drops 120 or 240 volts down to 24 volts, the transformer isn’t cost effective in short runs like a wall or ceiling heater.

From Wikipedia, the free encyclopedia

Voltage, otherwise known as electrical potential difference or electric tension (denoted ∆V and measured in volts, or joules per coulomb) is the potential difference between two points — or the difference in electric potential energy per unit charge between two points.[1] Voltage is equal to the work which would have to be done, per unit charge, against a static electric field to move the charge between two points. A voltage may represent either a source of energy (electromotive force), or it may represent lost or stored energy (potential drop).

A voltmeter can be used to measure the voltage (or potential difference) between two points in a system; usually a common reference potential such as the ground of the system is used as one of the points. Voltage can be caused by static electric fields, by electric current through a magnetic field, by time-varying magnetic fields, or a combination of all three.[2][3]

Definition

The voltage between two ends of a path is the total energy required to move a small electric charge along that path, divided by the magnitude of the charge. Mathematically this is expressed as the line integral of the electric field and the time rate of change of magnetic field along that path. In the general case, both a static (unchanging) electric field and a dynamic (time-varying) electromagnetic field must be included in determining the voltage between two points.

Historically this quantity has also been called “tension”[4] and “pressure”. Pressure is now obsolete but tension is still used, for example within the phrase “high tension” (HT) which is commonly used in thermionic valve (vacuum tube) based electronics.

Voltage is defined so that negatively-charged objects are pulled towards higher voltages, while positively-charged objects are pulled towards lower voltages. Therefore, the conventional current in a wire or resistor always flows from higher voltage to lower voltage. Current can flow from lower voltage to higher voltage, but only when a source of energy is present to “push” it against the opposing electric field. For example, inside a battery, chemical reactions inside